公司新聞
路拌機安全作業的程序與規程
來源:http://www.stkehao.cn/ 日期:2023-04-24
路拌機,穩定土拌和機,是一種自行式全液壓穩定土拌和設備,可對二灰土、二灰碎石、水穩沙礫等各種不同配比材料進行就地拌和,并可對舊瀝青路面進行銑刨。下面冷再生機租賃廠家來講講路拌機安全作業的程序與規程事項吧。
Road mixer, stabilized soil mixer, is a self-propelled fully hydraulic stabilized soil mixing equipment that can mix various materials with different proportions such as lime soil, lime crushed stone, water stabilized gravel, etc. on site, and can also mill old asphalt pavement. Let's talk about the procedures and regulations for the safe operation of road mixers from the rental manufacturers of cold recycling machines.
(一)作業程序
(1) Operating procedures
1.檢查氣壓表達到0.45Mpa以上時(正常值在0.6~0.8Mpa),松開停車制動器(手制動)。
1. When the air pressure is expressed above 0.45Mpa (normal value is between 0.6 and 0.8Mpa), release the parking brake (hand brake).
2.檢查各儀表達到規定示值,各報警燈熄滅。
2. Check that all instruments reach the specified values and all alarm lights turn off.
3.將變速換檔操縱桿撥至所需位置,發動機提速至1800~2000rpm,緩慢推動行走驅動手柄,將機械駛向作業地點。
3. Move the shift control lever to the desired position, increase the engine speed to 1800~2000rpm, slowly push the walking drive handle, and drive the machine towards the work site.
4.拉出前保險杠上示寬指示桿。
4. Pull out the width indicator bar on the front bumper.
5.將變速操縱桿置低速檔,緩慢搬動拌和轉子驅動手柄,使轉子達到工作轉速。
5. Set the speed control lever to low speed and slowly move the mixing rotor drive handle to reach the working speed of the rotor.
6.操縱大臂升降手柄,將拌和轉子下降到要求的拌和深度。
6. Operate the boom lifting handle to lower the mixing rotor to the required mixing depth.
7.操縱尾門操縱手柄,調整尾門開啟度至適當位置。
7. Operate the tailgate control handle and adjust the tailgate opening to the appropriate position.
8.緩慢推動行走手柄至機械達到作業行駛速度,開始拌和作業。
8. Slowly push the walking handle until the machine reaches the operating speed, and start the mixing operation.
(二)安全規程
(2) Safety regulations
1.制動氣壓低于0.45Mpa時,禁止松開手制動進入作業狀態。
When the brake pressure is lower than 0.45Mpa, it is prohibited to release the hand brake and enter the operating state.
2.正常行駛用高速檔,作業、大坡度爬坡或不平路行駛時,應用低速檔。
2. Use high gear for normal driving, and low gear for operations, steep slopes, or uneven roads.
3.在較長距離行駛時,拌和轉子大臂應提至高位,并用銷軸鎖住。
When driving over a long distance, the mixing rotor arm should be raised to a high position and locked with a pin.
4.換檔變速應停車進行。在小范圍變速時,可用行走液壓手柄操縱。
4. Shift and speed change should be stopped. When changing speed in a small range, it can be controlled by the walking hydraulic handle.
5.嚴禁不旋轉拌和轉子入土。
5. It is strictly prohibited to mix the rotor into the soil without rotation.
6.正常拌和作業不得隨意搬動轉子大臂升降手柄。
6. During normal mixing operations, it is not allowed to move the lifting handle of the rotor arm arbitrarily.
7.拌和材料中混有粒徑超過40MM的石料時,禁止進行拌和作業。
7. When stones with a particle size exceeding 40MM are mixed in the mixing material, mixing operations are prohibited.
8.發現異常聲響或有猛烈沖擊振動時,應及時停機檢查,解決后再作業。
8. When abnormal sounds or violent impact vibrations are found, the machine should be shut down for inspection in a timely manner, and the operation can only be carried out after resolving the issue.
9.應隨時檢查拌刀磨損情況,及時更換缺損拌刀,嚴禁缺刀作業。
9. The wear of the mixing knife should be checked at any time, and the missing mixing knife should be replaced in a timely manner. It is strictly prohibited to operate without a knife.
10.機械作業中,禁止人員上下,禁止檢修作業。
During mechanical operations, personnel are prohibited from getting up and down, and maintenance operations are prohibited.
路拌機安全作業的程序與規程相關內容就講解到這里了,希望您能夠有所了解,更多設備事項就來我們網站http://www.stkehao.cn咨詢了解吧!
That's all for the procedures and regulations related to the safety operation of road mixers. We hope you can have some understanding. For more equipment matters, please come to our website http://www.stkehao.cn Consult and understand!