公司新聞
冷再生機租賃廠家介紹改性瀝青生產設備的技術優勢！
來源：http://www.stkehao.cn/ 日期：2020-09-17
下面具體介紹改性瀝青生產設備的技術優勢，想要了解相關內容的小伙伴可以跟著冷再生機租賃廠家一起來看看。
The following describes the technical advantages of modified asphalt production equipment. If you want to know the relevant content, you can follow the rental manufacturer of cold recycling machine to have a look.
1、運行穩定，故障少。這個系列設備配備兩套獨立的加熱系統，就算是其中一套出現故障，另一套也可以支持設備生產，這樣就可以有效避免由于冷再生機改性瀝青設備故障而導致工期延誤。
1. Stable operation and few faults. This series of equipment is equipped with two sets of independent heating systems. Even if one of them fails, the other can support the production of the equipment, which can effectively avoid the delay of construction period caused by the failure of the modified asphalt equipment of the cold regenerator.
2、對瀝青適用面廣，可以使用各種國產瀝青作為基質瀝青來進行加工生產。
2. It has a wide range of applications, and can be processed and produced by using various domestic asphalt as base asphalt.
3、改性瀝青設備功能強大，不僅可以用于SBS改性瀝青生產，還可以用于膠粉改性瀝青及其他多種高粘度改性瀝青的生產。
3. The modified asphalt equipment has powerful functions, which can be used not only in SBS modified asphalt production, but also in rubber powder modified asphalt and other high viscosity modified asphalt production.
4、操作簡便，管理成本低。而且對技術人員要求不高。
4. The operation is simple and the management cost is low. And the requirements for technical personnel are not high.
冷再生機設備的工作效率跟操作者有很大的關系，操作方法正確那么其工作效率也高，如何正確的操作冷再生設備？
The working efficiency of cold regenerator equipment has a great relationship with the operator. If the operation method is correct, the working efficiency is also high. How to operate the cold regeneration equipment correctly?
1.使用后控制臺時，需將開關撥到后控制，此時前控制臺無作用，此外各個小噴頭開關可以使用后控制臺打開、關閉。
1. When using the rear console, turn the switch to the rear control. At this time, the front console does not work. In addition, each small nozzle switch can be opened and closed by using the rear console.
2.乳化瀝青設備不能灌的太滿，加油口蓋要關緊，運輸過程中以防瀝青溢出。
2. The emulsified asphalt equipment should not be filled too full, and the filler cap should be closed tightly to prevent asphalt overflow during transportation.
3.乳化瀝青設備在噴灑前一定要檢查各閥門位置是否正確。加入乳化瀝青設備內的熱態瀝青要達到160~180℃的工作溫度，長距離運輸或工作時間過長，可使用加溫裝置保溫，但不能當作熔油爐。
3. Before spraying emulsified asphalt equipment, check whether the valve position is correct. The hot asphalt added into the emulsified asphalt equipment should reach the working temperature of 160 ~ 180 ℃. If it is transported for a long distance or the working time is too long, the heating device can be used for heat preservation, but it can not be used as an oil melting furnace.
以上就是冷再生機租賃廠家介紹的全部內容了，關于其技術優勢就介紹這么多了，希望本文的介紹能對大家有幫助。
The above is the whole content introduced by the cold recycling machine rental manufacturer, so much about its technical advantages. I hope the introduction of this article can help you.
公司地址：濟南市槐蔭區經一路273號群盛華城2號樓1-404
公司名稱：山東途暢路橋工程有限公司 
備案號：