行業資訊
撒布車的相關保養方法
來源:http://www.stkehao.cn/ 日期:2023-04-24
撒布車是路面建設養護常用的一種設備,它能夠幫助我們快速鋪設路面,確保路面的質量與效率,但是設備需要定時定期的保護,才可以確保車輛的正常運行。冷再生機租賃小編就為大家詳細介紹撒布車保養方法
Spreader is a commonly used equipment for road construction and maintenance, which can help us quickly lay the road surface and ensure the quality and efficiency of the road surface. However, the equipment needs to be regularly protected to ensure the normal operation of the vehicle. The rental editor of the cold recycling machine will provide a detailed introduction to the maintenance methods of the spreader truck
1.車輛滿載時,需要注意中速行駛,如果遇到彎道、下坡提前做好減速準備,盡量避免急剎,并且行駛時需要嚴禁加熱。
When the vehicle is fully loaded, it is necessary to pay attention to driving at a medium speed. If encountering curves or downhills, prepare for deceleration in advance, try to avoid sudden braking, and strictly prohibit heating during driving.
2.檢查車輛、灑布裝置及防護、防火設備是否齊全有效,如果發現問題及時處理,避免引起危險;
2. Check whether the vehicle, spraying device, and protective and fire prevention equipment are complete and effective. If any problems are found, handle them promptly to avoid causing danger;
3.駕駛員與機上操作人員應密切配合,操作人員應注意自身的安全。作業時在噴灑瀝青方向10m以內不得有人停留。
3. The driver and onboard operators should closely cooperate, and the operators should pay attention to their own safety. During operation, no one shall stay within 10m of the direction of spraying asphalt.
4.采用固定式噴燈向瀝青箱的火管加熱時,應先打開瀝青箱上的煙囪口,并在液態瀝青淹沒火管后,方可點燃噴燈。
When using a fixed spray lamp to heat the fire pipe of the asphalt box, the chimney opening on the asphalt box should be opened first, and the spray lamp can only be ignited after the liquid asphalt submerges the fire pipe.
加熱噴燈的火焰過大或擴散蔓延時應立即關閉噴燈,待多余的燃油燒盡后再行使用。噴燈使用前,應先封閉吸油管及進料口,手提噴燈點燃后不得接近易燃品。
When the flame of the heating burner is too large or spreads, the burner should be immediately turned off and used only after the excess fuel has burned out. Before using the blowtorch, the oil suction pipe and feeding port should be closed first. After igniting the portable blowtorch, it is not allowed to approach flammable materials.
平時使用的時候我們要注意以下幾點:
When using it regularly, we should pay attention to the following points:
液壓系統所使用的液壓油為46#高清潔抗壓耐磨液壓油,補加的時候要特別注意,一定要把加油口處的粉塵清理干凈,并適量補加,不要超過觀察孔處的紅色點位,以免液壓油加多了產生外溢。如有外溢,請不要用水清洗,可選擇擦拭清理的方式處理。
The hydraulic oil used in the hydraulic system is 46 # high clean, pressure resistant, and wear-resistant hydraulic oil. Special attention should be paid when adding it. The dust at the oil filling port must be cleaned and an appropriate amount should be added, not exceeding the red dot at the observation hole, to avoid overflow caused by adding too much hydraulic oil. If there is any overflow, please do not use water to clean it. You can choose to wipe and clean it.
因工作環境特殊,粉塵量較大,液壓油箱的散熱片會沾附較多粉塵,粉塵的沾附會影響液壓油油溫的下降并增加散熱風扇的運轉時間。因此,油箱散熱片需要定期吹掃,吹掃的時候氣槍不要離散熱片過近,以免碰傷散熱片。
Due to the special working environment and high dust content, the cooling fins of the hydraulic oil tank may be contaminated with a large amount of dust, which can affect the decrease in hydraulic oil temperature and increase the operating time of the cooling fan. Therefore, the fuel tank heat sink needs to be regularly purged, and the air gun should not be too close to the heat sink during purging to avoid damaging it.
液壓油箱相關連接管件需要定期檢查,查看有無松動現象,如有松動,及時復緊,以免產生液壓油滲漏。
The relevant connecting fittings of the hydraulic oil tank need to be regularly inspected to see if there is any looseness. If there is looseness, it should be re tightened in a timely manner to avoid hydraulic oil leakage.
應特別注意,液壓油箱散熱風扇雖然會自動開啟降溫,但在使用過程中也會存在一定量的粉塵堆積,粉塵的堆積會影響散熱片的散熱效果,也會影響風扇的開啟與關閉時間,影響著散熱風扇的使用壽命。
Special attention should be paid to the fact that although the hydraulic oil tank cooling fan automatically starts to cool down, there may also be a certain amount of dust accumulation during use. The accumulation of dust can affect the heat dissipation effect of the cooling fins, as well as the opening and closing time of the fan, affecting the service life of the cooling fan.
撒布車的保養工作可以提高車輛的穩定性,讓設備能夠更好的運行,減少問題的發生,所以我們在使用中一定要注意這些問題,避免出現失誤。更多相關內容就來我們網站http://www.stkehao.cn咨詢!
The maintenance work of the spreader can improve the stability of the vehicle, enable the equipment to operate better, and reduce the occurrence of problems. Therefore, we must pay attention to these issues during use to avoid errors. For more related content, come to our website http://www.stkehao.cn consulting service